Search found 568 matches
- Sat Sep 08, 2012 8:25 am
- Forum: FZR600
- Topic: Disappointed with new SS Lines/R6s MC/Blue Dots
- Replies: 30
- Views: 2650
Air rises so it's hard to get the bobbles out at the bottom of the line at the caliper. A vacuum system that sucks the fluid in at the bleeder would work well but an alternative is to take the calipers off, put something between the pads to keep them from closing all the way. Then have someone else ...
Got the bike out of the bulk head started right up then died and wouldn't start. The little plastic splitters between the carbs were leaking fuel. Had to take it all back apart split the carbs and then try to actually find new o-rings. So got it back together and started so now that it's up, running...
- Fri Jun 01, 2012 4:25 am
- Forum: Electrical: MODs/How-To/Issues
- Topic: Headlight Brightness Fluctuates On Acceleration
- Replies: 5
- Views: 3269
Check your voltage I'd say your voltage regulator might be bad as you rev it up the voltage will increase causing the lights to brighten. Just check for 14.5 at the battery. If it is bad you can do a lot of electrical damage so check it soon
You would have to remove one end of the cable and use a spray lube with the little red tip and squirt it between the cable and coating. You could also take the cables off and submerge them in an oil or some thing of that nature. It could just be the cables are worn out and dragging inside the coatin...
Thanks It's actually a stock 99-02 r6 exhaust I bent the mount on the muffler and rotated it up. I wanted a high mount but I've spent so much already I'm gonna make what I have work. Here's a shot from the rear while I was doing a mock up. http://img.tapatalk.com/4c77147d-82f4-382d.jpg
ive been thinkin about getting the r6 tank how did it fit compared to the yzf600. im kinda torn between the two. i havent touched mine in months i been bulding a jeep from scratch and lost interest. just like me, one thing to the next.
- Sat May 07, 2011 6:55 am
- Forum: Hybrid Sportbike
- Topic: Swing arm swap so close help with 520 chain
- Replies: 4
- Views: 822
if your using the yzf600r engine an not the fzr then you dont have to space the chain out because the engine has it built in. use a sprocket with no collar on it or put the collar on the outside. i found a fzr front sprocket fits on the yzf