New Coils, leads and plug caps. Now won't start

FZR600 Forum

Moderators: Site Director, FZR Forum Moderators

buzzawak
Level 1.5
Level 1.5
Posts: 198
Joined: Wed Apr 29, 2009 4:09 am
Location: Newcastle, Australia

Re: New Coils, leads and plug caps. Now won't start

Postby buzzawak » Tue Jun 26, 2018 8:30 pm

If you have something solid causing a blockage sonic cleaning may not do it. You have to inspect each channel using compressed air and a length of wire.
I am have asked you this but how are you emulation tubes?

chris-seed
50+ Posts
50+ Posts
Posts: 64
Joined: Wed Aug 06, 2014 7:02 am
Location: Stockport, UK

Re: New Coils, leads and plug caps. Now won't start

Postby chris-seed » Thu Jun 28, 2018 8:28 am

That's a good point. I haven't clean anything out with air or wire. I did take the carbs apart completely though. So all of the jets and emulsion tubes came out and got cleaned individually. I then sprayed carb cleaner through everything.

I haven't fully checked the emulsion tubes. They're all intact, but I'm not sure if any of them are deformed or not.

User avatar
Rayman
Site Newbie
Posts: 6
Joined: Thu Sep 22, 2016 12:32 am
Contact:

Re: New Coils, leads and plug caps. Now won't start

Postby Rayman » Fri Jul 27, 2018 5:06 am

treid new plugs and synched the carbs -
mine started fine after an engine swap -
went away for two weeks came back - just coulnt get it to run - not even on ether -
went and got new plugs - old ones turned otu to be very sooty- ( came i nthe swapped engine)
first press of the starter - away she went.

Rayman
Ignition Modules and other stuff
www.rae-san.com


cx500A - grey - commuter (phantom) SOLD
cx500B+ - undertail exhaust - complete (Storm) SOLD
vf750f - complete but needs a repaint and rings
vf750s - complete - sold
vf750s - fiddler - vf1000f forks, ignition trail, 4into1, pods, clip ons, dual headlights etc
next cx - cx500 in 650 frame with undertail pipes and lots of changes - almost done
91 - fzr600 New project


Return to “FZR600”

Who is online

Users browsing this forum: No registered users and 4 guests