User Tools

Site Tools


remove_the_flywheel

How to Remove the Flywheel

Time: 30 minutues

Required Tools:

Directions:

  1. Use the 5mm allen tool to remove the stator cover (left side of bike)
  2. Remove the bolt in the middle of the flywheel (you may need a breaker bar)
  3. Screw in the flywheel puller (tighten to around 20 Nm or so, as long as its not loose)
  4. Take a hammer and whack the flywheel puller (Careful, don't damage the flywheel)
  5. It may take a few whacks for the flywheel to loosen, it should then just slide right off
  6. After removing the flywheel there should be a flywheel key (a little half moon shaped bit of metal ) that holds it in place, don't lose this.

CLICK HERE


- icontender

remove_the_flywheel.txt · Last modified: 2009/02/02 11:31 by 80.177.31.81