User Tools

Site Tools


This is an old revision of the document!

How to Remove the Flywheel

Time: 30 minutues

Required Tools:


  1. Use the 5mm allen tool to remove the stator cover (left side of bike)
  2. Remove the bolt in the middle of the flywheel (you may need a breaker bar)
  3. Screw in the flywheel puller (tighten to around 20 Nm or so, as long as its not loose)
  4. Take a hammer and whack the flywheel puller (Careful, don't damage the flywheel)
  5. It may take a few whacks for the flywheel to loosen, it should then just slide right off
  6. After removing the flywheel there should be a flywheel tab that holds it in place, don't lose this.


- icontender

remove_the_flywheel.1218293081.txt.gz · Last modified: 2008/08/09 14:44 by